Select Cable Components; Select Cable Removal And Installation; Select Cable Adjustment - Suzuki 2006 SX4 Service Manual

5A-70 Automatic Transmission/Transaxle:

Select Cable Components

(a)
3
5
(c)
4
1. Select lever assembly
2. Select cable
3. Cable bracket
4. Manual select lever
5. Clip

Select Cable Removal and Installation

Removal
1) Remove parking brake lever cover.
2) Remove console box.
3) Disconnect select cable from select lever and then
detach from bracket.
4) Remove clip and disconnect select cable from
manual shift.
5) Remove select cable retainer from dash panel.
Installation
Install select cable by reversing removal procedure.
The important steps in installation are as follows.
• Apply grease to pin and cable joint.
• Tighten bolts to specified torque referring to "Select
Cable Components".
• Adjust select cable referring to "Select Cable
Adjustment".
11 12
2
(b)
6
A
6. Manual select lever pin
: Apply lithium grease 99000-25010 to all around pin (0.15 g)
7. Select lever pin
: Apply lithium grease 99000-25010 to all around pin (0.15 g)
8. Adjuster case
9. Lock
10. EPS control module (EPS model)
S6RW0C5106011
7
8
10

Select Cable Adjustment

1) Remove adjuster (cable end) from select lever pin of
select lever assembly.
2) Shift manual shift lever (1) to "N" range (transmission
range sensor "N" range) aligning arrow (2) of lever
(1) with "N" reference line (3).
3
S6RW0C5106010
A
9
1
I7RW01510034-01
11. Heater inlet hose
12. Clamp
: 23 N⋅m (2.0 kgf-m, 17.0 lb-ft)
: 6.5 N⋅m (0.65 kgf-m, 5.0 lb-ft)
: 12 N⋅m (1.2 kgf-m, 8.0 lb-ft)
S6RW0C5106012
1
2
I4RH01510025-01