Dtc P0717: Input Speed Sensor "A" Circuit No Signal - Suzuki 2006 SX4 Service Manual

Step
3 Check transmission fluid temperature sensor circuit for
IG short
1) Cool down A/T fluid temperature under ambient
temperature.
2) Connect TCM connectors to TCM with ignition switch
turned OFF.
3) Turn ignition switch to ON position.
4) Measure voltage between terminal "C06-11" of TCM
connector and ground.
Is it 5 V or more?
4 Check transmission fluid temperature sensor
1) Check transmission temperature sensor for resistance
referring to "Transmission Fluid Temperature Sensor
Inspection".
Is it in good condition?

DTC P0717: Input Speed Sensor "A" Circuit No Signal

Wiring Diagram
1. TCM
2. Input shaft speed sensor
DTC Detecting Condition and Trouble Area
DTC detecting condition
Pulse signals of input shaft speed sensor are not input although
pulse signals of output shaft speed sensor are input while
vehicle is running.
(1 driving cycle detection logic)
Action
BLK
2
WHT
C06
6 5
4 3 2 1
16 15 14 13 12 11 10 9 8 7
24 23 22 21 20 19 18 17
3. Terminal arrangement of TCM connector (viewed from harness side)
Automatic Transmission/Transaxle:
Yes
"LT GRN" circuit shorted
to power circuit. If circuit
is OK, go to Step 4.
Intermittent trouble or
faulty TCM. Check for
intermittent referring to
"Intermittent and Poor
Connection Inspection
in Section 00". If OK,
substitute a known-
good TCM and recheck.
1
C07-6
C07-16
2.5V
C07
6 5 4 3 2 1
17 16 15 14 13 12 11 10 9 8 7
21 20 19 18
26 25 24 23 22
• Input shaft speed sensor or its circuit malfunction.
• Improper input shaft speed sensor installation.
• Damaged forward and direct clutches drum.
• Foreign material attachment to sensor or drum.
• TCM
No
Intermittent trouble or
faulty TCM. Check for
intermittent referring to
"Intermittent and Poor
Connection Inspection
in Section 00". If OK,
substitute a known-
good TCM and recheck.
Replace transmission
fluid temperature
sensor.
S6RW0C5104023
3
I7RW01510010-01
Trouble area
5A-43