Dtc C1041 / C1042 / C1045 / C1046 / C1051 / C1052 / C1055 / C1056: Inlet / Outlet Solenoid - Suzuki 2006 SX4 Service Manual

DTC C1041 / C1042 / C1045 / C1046 / C1051 / C1052 / C1055 / C1056: Inlet / Outlet Solenoid

DTC C1041 / C1045 / C1051 / C1055: Right-Front / Left-Front / Right-Rear / Left- Rear Inlet Solenoid
DTC C1042 / C1046 / C1052 / C1056: Right-Front / Left-Front / Right-Rear / Left- Rear Outlet Solenoid
Wiring Diagram
WHT/BLU
2
1
BLK
[A]: ABS control module assembly connector (viewed from terminal side)
1. Battery
2. Main fuse box
3. Solenoid valve
DTC Detecting Condition and Trouble Area
DTC Detecting Condition
DTC C1041, C1042, C1045, C1046, C1051, C1052,
C1055, C1056:
• Solenoid valve circuit is opened, shorted to power,
ground and/or each valve in ABS hydraulic unit / control
module assembly.
• Mismatching solenoid output and solenoid monitor is
detected.
DTC Troubleshooting
Step
1 Was "ABS Check" performed?
2 ABS hydraulic unit / control module power source
circuit check
1) Turn ignition switch to OFF position.
2) Disconnect ABS hydraulic unit / control module
connector.
3) Check for proper connection to ABS hydraulic unit /
control module connector at terminal "E08-24" and "E08-
23".
4) If OK, then measure voltage between terminal "E08-24"
of module connector and "E08-23".
Is it 10 – 14 V?
E08-24
5
4
6
E08-23
Action
3
4. ABS hydraulic unit / control module assembly
5. Solenoid valve power supply driver (transistor)
6. Solenoid valve driver
Trouble Area
• ABS control module
Yes
Go to Step 2.
Substitute a known-
good ABS hydraulic unit
/ control module
assembly and recheck.
ABS: 4E-23
S6RW0C4504017
[A]
E08
1
12
2
13
3
14
4
15
5
16
6
17
7
18
8
19
9
20
10
21
11
22
23
24
25
26
I7RW01450008-02
No
Go to "ABS Check".
"WHT/BLU" or "BLK"
circuit open or high
resistance.