Differential Side Oil Seal Replacement; A/T Fluid Cooler Hoses Replacement - Suzuki Liana RH418 Supplementary Service Manual

Differential Side Oil Seal Replacement

1) Lift up vehicle and drain automatic transaxle fluid.
2) Remove drive shaft joints from differential gear of
transaxle. Refer to "Front Drive Shaft Assembly
Removal and Installation in Section 3A" for
procedure to disconnect drive shaft joints.
For differential side oil seal removal, it is not
necessary to remove drive shafts from steering
knuckle.
3) Remove differential side oil seal by using screw
driver or like.
4) Apply grease to new differential side oil seal lip.
: Grease 99000–25030
5) Install new differential side oil seal (1) by using
special tool.
NOTE
For oil seal installation, press-fit oil seal so
that transaxle case end face (2) is flush with
oil seal end face.
Special tool
(A): 09944-66020
6) Install drive shaft referring to "Front Drive Shaft
Assembly Removal and Installation in Section 3A".
7) Pour A/T fluid referring to "A/T Fluid Change".

A/T Fluid Cooler Hoses Replacement

S3RH0B5106019
The rubber hoses for the A/T fluid cooler should be
replaced at specified interval. When replacing them, be
sure to note the following.
• to replace clamps at the same time
• to insert hose as far as its limit mark
• to clamp clamps securely
I2RH01510076-01
Automatic Transmission/Transaxle:
1. Radiator
2. Inlet hose (Outlet from A/T fluid cooler)
3. Outlet hose (Inlet to A/T fluid cooler)
5A-77
S3RH0B5106022
I3RH0B510011-01