Pistons, Piston Rings And Connecting Rods Removal And Installation - Suzuki Liana RH418 Supplementary Service Manual

1D-46 Engine Mechanical:
Pistons, Piston Rings and Connecting Rods
Removal and Installation
Removal
1) Remove engine assembly from vehicle referring to
"Engine Assembly Removal and Installation".
2) Remove cylinder head referring to "Valves and
Cylinder Head Removal and Installation".
3) Mark cylinder number on all pistons, connecting rods
and connecting rod caps using silver pencil or quick
drying paint.
4) Remove rod bearing caps.
5) Install guide hose (1) over threads of rod bolts.
This prevents damage to bearing journal and rod bolt
threads when removing connecting rod.
6) Decarbonize top of cylinder bore before removing
piston from cylinder.
7) Push piston and connecting rod assembly out
through the top of cylinder bore.
Installation
NOTE
Make sure that checking for deformation of
connecting rod bolt. Refer to "Piston Pins
and Connecting Rods Inspection".
1) Apply engine oil to pistons, rings, cylinder walls,
connecting rod bearings and crankpins.
NOTE
Do not apply oil between connecting rod and
bearing or between bearing cap and bearing.
2) Install guide hoses (1) over connecting rod bolts.
These guide hoses protect crank pin and threads of
rod bolt from damage during installation of
S3RH0B1406030
connecting rod and piston assembly.
3) When installing piston and connecting rod assembly
into cylinder bore, point front mark (1) on piston head
to crankshaft pulley side.
I2RH0B140109-01
4) Install piston and connecting rod assembly into
cylinder bore. Use special tool (Piston ring
compressor) to compress rings. Guide connecting
rod into place on crankshaft.
Using a hammer handle, tap piston head to install
piston into bore. Hold ring compressor firmly against
cylinder block until all piston rings have entered
cylinder bore.
Special tool
(A): 09916–77310
A: Crankshaft pulley side
B: Flywheel side
I2RH01140147-01
I2RH0B140110-01
I2RH0B140111-01