Front Drive Shaft Disassembly And Assembly - Suzuki Liana RH418 Supplementary Service Manual

Front Drive Shaft Disassembly and Assembly

Disassembly
For tripod joint type
1) Remove differential side boot big band, and then
take out joint housing (1).
2) Wipe off grease from shaft and take off snap ring (1)
using special tool.
Special tool
(A): 09900-06107
3) Remove spider (1) using 3 arms puller (2).
CAUTION
!
To prevent any problem caused by washing
solution, do not wash tripod joint except its
housing. Degreasing of tripod joint with cloth
is allowed.
4) Remove differential side boot small band, and then
S3RH0B3106004 pull out differential side boot from shaft.
5) Remove damper band, and then pull out damper
through shaft.
6) Remove wheel side boot big band (1) using flat end
rod or the like.
7) Remove wheel side boot small band (2), and then
pull out wheel side boot from shaft.
CAUTION
!
• Disassembly of wheel side joint is not
allowed. If any noise or damage exists in it,
replace it as assembly.
• Do not disassemble tripod joint spider. If
any malcondition is found in it, replace it
as differential side joint assembly.
I2RH01310008-01
For DOJ type
1) Remove differential side boot big band (1).
I3RH0A311009-01
I3RH0A311004-01
Drive Shaft / Axle:
1
2
3A-4
I3RH0B311001-01
I2RH01310011-01