1D-36 Engine Mechanical:
Valves and Cylinder Head Components
1. Valve cotters
2. Valve spring retainer
3. Valve spring
4. Valve stem seal
5. Valve spring seat
6. Intake valve
7. Exhaust valve
8. Valve guide
9. Cylinder head bolt for M10
: Make sure cylinder head bolt (M10) diameter when reuse it due to
plastic deformation tightening referring to "Valves and Cylinder Head
Removal and Installation".
: Tighten 20 N⋅m (2.0 kgf-m, 14.5 lb-ft), 40 N⋅m (4.0 kgf-m, 29.0 lb-ft),
60° and 60° by the specified procedure.
10. Cylinder head
11. Cylinder head gasket
: "TOP" mark provided on gasket comes to crankshaft pulley side,
facing up.
12. Knock pin
S3RH0B1406023
I3RH0B140044-01
13. Cylinder head bolt for M8
: Tighten 25 N⋅m (2.5 kgf-m, 18.0 lb-ft)
by the specified procedure.
: Tightening torque
: Do not reuse.
: Apply engine oil to sliding surface of
each part.