Rear Wheel Hub Assembly Removal And Installation - Suzuki 2006 SX4 Service Manual

Rear Wheel Hub Assembly Removal and
Installation
CAUTION
!
Do not allow brake fluid to get on painted
surfaces. Painted surface will be damaged.
Removal
1) Hoist vehicle. Then remove rear wheel and brake
drum.
2) For 4WD model, remove rear drive shaft referring to
"Rear Drive Shaft Assembly Removal and
Installation in Section 3A".
3) Remove rear brake shoe.
4) Disconnect brake pipe flare nut (1) from wheel
cylinder (3) and put bleeder plug cap (4) onto pipe
(2) to prevent fluid from spilling.
3
4
S6RW0D2306012
1
2
I5RW0A230024-01
5) Disconnect wheel speed sensor (1).
6) Remove brake back plate (2) and rear wheel hub
from rear axle.
[A]
[B]
[A]: 4WD model
[B]: 2WD model
7) If necessary, remove wheel stud bolts (1) with
copper hammer or hydraulic press.
CAUTION
!
Never remove bolt unless replacement is
necessary.
Be sure to use a new bolt for replacement.
Rear Suspension: 2C-8
2
1
1
I7RW01230018-01
1
I5JB0A220016-01