Replacing the Fusing Unit, the Transfer Unit, and the Retard Roller
You need to replace all three parts (the fusing unit, transfer unit, and retard roller) at a time. Both the transfer unit
and the retard roller for replacement come with a new fusing unit.
WARNING:
Before performing any of the following procedures, read and follow the safety instructions in the
Information
.
Removing the Fusing Unit
1 Turn off the printer, and wait for 40 minutes.
2 Pull the rear cover handle to open the rear cover.
3 Raise the two gray levers on the both sides of the fusing unit to unlock.
4 Grasp the grips on both sides of the fusing unit, and then pull out the unit.
452
Maintaining Your Printer
Important