Table of Contents
Advertisement
OWNER'S HANDBOOK
3.
Set the Power Savings option to 'Customized'
4.
Set the Auto Suspend timeout to the desired
value.
5.
Exit from the Setup utility using the 'Exit Saving
Changes' option.
Note
For the Auto Suspend timeout option to operate, you
need to enter a value in the Standby timeout option.
Using the display lid switch
You can set your computer to enter Suspend mode
when you close the display lid.
1.
Enter the Setup utility by pressing the F2 button
when prompted during Startup.
2.
Select Lid Switch from the Power menu, and set
it to 'Suspend'.
3.
Exit from the Setup utility using the 'Exit Saving
Changes' option.
The computer will now enter Suspend mode when
you close the display lid. Press the Power switch to
resume normal operation.
4 / 8
B a t t e r y a n d P o w e r M a n a g e m e n t
Suspend mode on a network
If using your computer on a network, do not use Suspend
mode, otherwise your computer may not remain visible to
other computers on the network.
Windows NT users
The Suspend function should not be used with any
version of Windows NT.
Enabling audible 'low battery' warning
As mentioned in the battery section, your computer
gives you an audible warning when the battery is low
on charge. This can be enabled in Setup as follows:
1.
Enter the Setup utility by pressing the F2 button
when prompted during Startup.
2.
Select Low Battery Beep from the Power menu,
and set it to 'Enabled'.
3.
Exit from the Setup utility using the 'Exit Saving
Changes' option.
Advertisement
Table of Contents
