Choosing Preset Sound; Night Mode - Sanyo FWSB426F Owner's Manual

Choosing Preset Sound

1
Press either
preset sound suitable for the Audio that is playing.
2
The LED in the center (OPTICAL/COAXIAL) blinks yellow once.
3
When the preset sound setting is set, LED indicators go back to the current Input.
NOTE(S)
• Select any Preset Sound according to your preference, regardless of categories.
• The default Preset Sound is MOVIE.
• This setting will remain while the Soundbar is in Standby mode.

Night Mode

Night Mode 1
Turns down the Volume on the Subwoofer. It is useful late at night.
1
To switch the unit to Night Mode 1, press
Night Mode 2* (Dynamic Range Control)
Adjusts for clarity even when the Volume is Low, by compressing the range of the lowest sound level and the highest sound level.
1
To switch the unit to Night Mode 2, press and hold
* This function is only effective for Dolby Digital sounds.
* This function is only available when the Soundbar is connected via Optical or Coaxial.
Mode
LINE
Night Mode 1
LINE
Night Mode 2
Input Source
OPTICAL/COAXIAL Dolby Digital
PCM
LINE
AUX
USB
BLUETOOTH
NOTE(S)
• The Default setting of both Night Modes is Off.
• These Settings will remain while the Soundbar is in Standby mode, so again use
current mode to the next mode.
EN
, , ,
LED lighting patterns
USB USB OPTICAL/ OPTICAL/ AUX AUX PAIR
COAXIAL COAXIAL
USB USB OPTICAL/ OPTICAL/ AUX AUX PAIR
COAXIAL COAXIAL
Night Mode 1 Night Mode 2
✔
✔
✔
✔
✔
✔
, or on the Remote Control to select the desired
.
.
LED behavior
On: Lowers the Volume of the Subwoofer.
On: Flashes 4 times
Off: Outputs the Sound at the same Volume
Off: Flashes twice
On: Turns down loud sounds and turns up
On: Flashes 4 times
Off: Flashes twice
Off: Outputs the Sound at the same Volume
✔
―
―
―
―
―
– 14 –
Sound effects
as the original.
soft sounds in order to keep voices at a
comfortable Volume.
as the original.
to turn the mode from