Charging Process - DeWalt DCT410 Original Instructions Manual

Eng lis h
CAUTION: Children should be
supervised to ensure that they do not
play with the appliance.
NOTICE: Under certain conditions, with
the charger plugged in to the power
supply, the charger can be shorted by
foreign material. Foreign materials of
a conductive nature such as, but not
limited to, grinding dust, metal chips,
steel wool, aluminum foil, or any buildup
of metallic particles should be kept away
from charger cavities. Always unplug the
charger from the power supply when
there is no battery pack in the cavity.
Unplug charger before attempting to
clean.
• DO NOT attempt to charge the battery pack
with any chargers other than the ones in
this manual. The charger and battery pack are
specifically designed to work together.
• These chargers are not intended for
any uses other than charging D
rechargeable batteries. Any other uses
may result in risk of fire, electric shock or
electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when
disconnecting charger. This will reduce risk
of damage to electric plug and cord.
• Make sure that cord is located so that it
will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
• Do not use an extension cord unless it
is absolutely necessary. Use of improper
extension cord could result in risk of fire,
electric shock, or electrocution.
• Do not place any object on top of charger
or place the charger on a soft surface that
might block the ventilation slots and result
in excessive internal heat. Place the charger
in a position away from any heat source. The
charger is ventilated through slots in the top and
the bottom of the housing.
• Do not operate charger with damaged cord
or plug — have them replaced immediately.
• Do not operate charger if it has received
a sharp blow, been dropped, or otherwise
damaged in any way. Take it to an authorised
service centre.
• Do not disassemble charger; take it to an
authorised service centre when service or
repair is required. Incorrect reassembly may
result in a risk of electric shock, electrocution or
6
• In case of damaged power supply cord the
• Disconnect the charger from the outlet
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on
Chargers
The DCB105, DCB107 and DCB112 chargers
accept 10.8 V Li-ION batteries.
WALT
e
These chargers require no adjustment and are
designed to be as easy as possible to operate.
Charging procedure (fig. 1)
1. Plug the charger into an appropriate outlet
2. Insert the battery pack (a) into the charger.
3. The completion of charge will be indicated by
NoTE: To ensure maximum performance and life of
Li-ION batteries, charge the battery pack fully before
first use.

Charging process

Refer to the table below for the state of charge of
the battery pack.
fire.
supply cord must be replaced immediately by
the manufacturer, its service agent or similar
qualified person to prevent any hazard.
before attempting any cleaning. This will
reduce the risk of electric shock. Removing
the battery pack will not reduce this risk.
standard 230V household electrical power.
Do not attempt to use it on any other
voltage. This does not apply to the vehicular
charger.
Save tHeSe inStructionS
before inserting battery pack.
The red (charging) light will blink continuously
indicating that the charging process has started.
the red light remaining ON continuously. The
pack is fully charged and may be used at this
time or left in the charger.
State of charge - DCB105
charging
fully charged
hot/cold pack delay
replace battery pack
– – – –
–––––––––––
–– – –– –
•••••••••••