About The Remote Control Signal - Hitachi CP-WU5500 User Manual

About the remote control signal

The remote control works with
the projector's remote sensor.
This projector has a remote
sensor on the front.
The sensors can sense signals
within the following range:
60 degrees (30 degrees to the
left and right of the sensor)
within about 3 meters.
NOTE
• You can deactivate one of the sensors using the REMOTE RECEIV.
item in the SERVICE menu of the OPTION menu (89).
• The remote control signal refl ected in the screen or the like may be available.
If it is diffi cult to send the signal to the sensor directly, attempt to make the
signal refl ect.
• The remote control uses infrared light to send signals to the projector (Class 1
LED), so be sure to use the remote control in an area free from obstacles that
could block the remote control's signal to the projector.
• The remote control may not work correctly if strong light (such as direct
sun light) or light from an extremely close range (such as from an inverter
fl uorescent lamp) shines on the remote sensor of the projector. Adjust the
position of projector avoiding those lights.
(approx.)
3m
30° 30°
Remote control
29