Making Calls - Panasonic KX-NT700 Operating Instructions Manual

Making and Answering Calls

Making Calls

Making a Call to a Phone Number or
IP Address
1.
Confirm that the desired line ("IP" or "TEL") is
selected.
•
You can change the selected line by pressing
the center function button ([F2]).
The IP line is selected.
[F2]
•
If you cannot select the desired line, change the
"Line Selection" setting (see page 33).
2.
Press [ ].
3.
Enter the phone number or IP address.
•
IP addresses can be entered using the keypad.
[0]–[9] are used to enter numbers and [ ] is
used to enter a period. For example, to enter
"192.168.0.1", press [192 168 0 1]. After
entering the IP address, press [#] or [ENTER].
•
To temporarily use tone dialing when the line
mode is set to pulse mode, press [ ].
•
After a call starts, the approximate length of the
call is shown on the display.
4.
To end the call, press [
Note
•
To make a call to a SIP extension number or
SIP URI, see page 34.
•
To make a call using the phonebook, see
page 35.
•
To make a call with a Portable Station (PS) or
computer connected to the unit, see page 44
or page 45.
•
During the first 30 seconds of a TEL call, the unit
adjusts itself for optimal sound quality. Speak in
turns with the other party at the beginning of a
conversation. (The time required varies
depending on the condition of the telephone line
and the audio characteristics of the room.)
During this time, sound may cut out or fade in
and out. This is normal.
34 Operating Instructions
The TEL line is
selected.
[F2]
].
•
If the unit is not connected to an IP network,
is not displayed and the IP line cannot
IP
be selected.
•
The call length shown on the display is an
approximation and may differ from the actual
length of the call. Call charges accumulate after
the called party answers.
Making a Call to a SIP Extension
Number or SIP URI
1.
Confirm that the "IP" line is selected.
•
You can change the selected line by pressing
the center function button ([F2]).
The IP line is selected.
[F2]
•
If you cannot select the desired line, change the
"Line Selection" setting (see page 33).
2.
Enter the SIP extension number or SIP URI.
•
To enter a SIP URI:
1.
Press a dial key.
The center function button icon will change
to .
URI
2.
Press
URI
3.
"sip:" is displayed automatically. Enter the
SIP URI after the colon.
Example:
sip:User name*
(max. 32 characters) (max. 64 characters)
*1 You can also enter a SIP extension number
instead of a user name.
*2
To enter @, press
character entry mode to alphabet entry mode,
then press [#] once.
*3 You can also enter an IP address instead of a
domain name.
If a domain name is not entered after the @, the
value specified in "SIP User Domain
Name" is used as the domain name when dialing
(see page 56).
to select SIP URI.
1 2 3
@* Domain name*
CHAR to switch the
Document Version 2011/06
.