Mount Arm Assemblies; Mount Bumper Assembly; Install Handle Assembly - Toro 30425 Groundsmaster 4000–D Operator's Manual

Mount Arm Assemblies

1. Align the rear set of mounting holes in each lift arm
with holes in the blower housing mounting brackets.
Position lift arms as shown in figure 5.
2. Loosely secure each lift arm to mounting bracket with
(2) capscrews, flatwashers and locknuts. Do not tighten
locknuts.
2
3
Figure 5
1. Lift arm
2. Blower housing

Mount Bumper Assembly

1. While aligning mounting holes, position bumper
assembly onto lift arms (Fig. 6).
2. Loosely secure bumper assembly to each lift arm with
(4) capscrews, flatwashers and locknuts.
1
3. Mounting brackets
Figure 6
1. Bumper assembly

Install Handle Assembly

1. Position handle mounting tube between tabs on top of
blower housing (Fig. 7).
Note: When mounting a debris blower on a traction unit
equipped with a cab, rotate handle 180_ when installing.
2. Secure each end of tube to a housing tab with a
capscrew and flatwasher.
Figure 7
1. Handle assembly
3. Insert handle grip onto handle (Fig. 7).
9
1
2
1
2. Handle grip