Mount The Chute Assembly - Toro 30357 Operator's Manual

7. Push down on the rear of the cutting unit and insert
the height of cut rods through the lift arm pads.
8. Install the height of cut collars onto the height of
cut rods and secure with the clevis pins and hair pin
cotters (Figure 19). The head of the clevis pin is to be
positioned toward the front of the deck.
9. Install a 1/2 x 3/4 inch capscrew and a washer to the
top of each height of cut rod
Figure 19
1. Lift arm
2. Castor arm bracket
3. Height of cut rod
4. Lift arm pads
5. Thrust washers
6. Clevis pin
(Figure 19).
7. Hair pin cotter
8. Height of cut collar
9. Clevis pin
10. Hair pin cotter
11. Capscrew
5

Mount the Chute Assembly

Parts needed for this procedure:
1 Chute assembly
2 Chute bracket
4 Locknut, 5/16 in
Procedure
1. Set the cutting unit to the desired height of cut.
2. Slide the chute assembly over the blower opening and
onto the mounting studs
3. Lower the hopper hood and align the chute with the
hood snout. Secure the chute to the blower with 4
5/16 inch locknuts and 2 chute brackets
1. Chute assembly
13
(Figure 20).
(Figure
Figure 20
2. Chute bracket 2
20).