4. Pivot the locking lever to the right to lock the
adapters together.
5. Connect the attachment hydraulic hose couplers
to the hydraulic couplers on the traction unit rear
remote hydraulics kit.
Important: Whenever the hydraulic hose
couplers are disconnected, make sure the dust
plugs are installed to prevent contamination
from entering either hydraulic system.
2
Adjusting the Link Assembly
No Parts Required
Procedure
1. With the debris blower mounted and secured on the
traction unit, raise the attachment.
2. Measure the gap between the top washer and the
spacer in the link assembly on the attachment
adapter as shown in Figure 4.
Note: The gap between the washer and the shoulder
should be 0.060 to 0.080 inch
2
3
1
G00381 1
1. 0.060 to 0.080 inch
2. Jam nut
Figure 4
3. Adjustment nut
3
Grease the Blower
No Parts Required
Procedure
Before the Debris Blower is operated, it must be greased
to assure proper lubrication. Refer to Lubrication
section of manual. Failure to properly grease the unit
will result in premature failure of critical parts.
7