Table of Contents
Advertisement
3
Adjusting the Link Assembly
No Parts Required
Procedure
1. With the debris blower mounted and secured on the
traction unit, raise the attachment.
2. Measure the gap between the top washer and the
spacer in the link assembly on the attachment
adapter as shown in Figure 6.
Note: The gap between the washer and the shoulder
should be 0.060 to 0.080 inch
2
3
1
G00381 1
1. 0.060 to 0.080 inch gap
2. Jam nut
Figure 6
3. Adjustment nut
4
Grease the Blower
No Parts Required
Procedure
Before the Debris Blower is operated, it must be greased
to assure proper lubrication. Refer to Lubrication
section of manual. Failure to properly grease the unit
will result in premature failure of critical parts.
5
Install Front Weight
No Parts Required
Procedure
When an attachment is not installed on the
machine, loose weights must be removed.
Never operate the machine with no attachment
installed and front weights on the machine
Use the following weight charts to determine the correct
amount of front weight required for your machine.
8
Advertisement
Table of Contents
