Indicator Control Module; Driving Forward Or Backward - Toro 266H Wheel Horse 72052 Operator's Manual

Lawn and garden tractor
Hide thumbs Also See for 266H Wheel Horse 72052:
Table of Contents

Advertisement

3. Set the parking brake, move the power take off (PTO)
to off and move the hydro control pedal forward from
the neutral; the engine should not crank.
4. Set the parking brake and move the power take off
(PTO) to off. Now start the engine. While the engine is
running, release the parking brake and rise slightly
from the seat; the engine should stop.
5. Set the parking brake and restart the engine. While the
engine is running, and the parking brake is engaged,
move the hydro pedal forward; the engine should
stop.
6. With the parking brake released, turn the ignition key
to RUN without starting the engine. Pull the PTO
switch to on. You should hear an audible click
indicating the PTO is activated and the PTO light will
illuminate. Move the foot pedal to reverse. You should
hear an audible click indicating the PTO is deactivated
and the PTO light should turn off.
7. With the parking brake released, turn the ignition
switch to run without starting the engine. Pull the PTO
switch to on. Turn the KeyChoice key and release. The
Operating-in-Reverse warning light should illuminate.
Move the foot pedal to reverse. The PTO and PTO
light on the dash should remain on. Push the PTO
switch to off. The PTO light and the
Operating-in-Reverse warning light should turn off.

Indicator Control Module

The indicator control module (Fig. 12) lights when the
parking brake or power take off (PTO), is actuated and
when there is a problem of low oil pressure or alternator
output, that needs immediate attention.
1
2
Figure 12
1. Operating–in–Reverse
2. Battery
3. Hourmeter
Following are the conditions when indicator lights will be
"ON". At other times the lights should be off.
Operating in Reverse
The Operating-in-Reverse light will illuminate whenever
the KeyChoice switch is used to deactivate the
operating-in-reverse interlock. It is a reminder that the
3
4
5
4. Oil
5. PTO (power take off)
interlock system is deactivated. The light goes out
whenever the power take off (PTO) is disengaged or the
engine is shut off.
Battery
The battery light will be on when the key is in the run or
lights positions if the battery voltage is below 12.6 volts
or when the engine is running and the alternator output is
above 14.8 volts. When this light comes on it is important
to have your battery and electrical system checked and the
problem corrected.
Hourmeter
The hourmeter records the number of hours the engine has
operated (Fig. 12). It is turned on when the ignition switch
is in the run or lights positions. Use the times for
scheduling regular maintenance.
Oil
The oil light will be on when the key is in the run or lights
positions and the engine is not running, after the engine is
started the light should go out. When the engine is running
if the oil pressure drops below a safe operating level the
light comes on. When the light comes on while the engine
is running, Stop engine immediately and correct the
cause of low oil pressure.
PTO (Power Take Off)
The PTO (power take off) light will be on when the key is
in the run or lights positions and the PTO (power take off)
is engaged on. When this light is on it is a reminder; the
starter will not crank and turn off the PTO before getting
off.

Driving Forward or Backward

The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place the
throttle control in the fast position for best performance.
To go forward or backward, release the parking brake;
refer to Releasing the Parking Brake, page 15. Place your
foot on the traction control pedal and slowly press on the
top of the traction control pedal to move forward or on the
bottom of the traction control pedal to move backward
(Fig. 13). The fatherr you move the traction control pedal
in either direction, the faster the machine will move in
that direction.
Note: For reverse motion, with the PTO engaged, the
operating-in-reverse interlock must be deactivated by the
KeyChoice switch located on the seat bracket on the right
hand side just below the seat.
18

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents