1
G017939
(Rear of machine shown)
1. Parking brake
Hydrostatic-drive Bypass Lever
The hydrostatic-drive bypass lever
hydrostatic-drive system so you can move the machine by
hand, without the engine running.
For normal operating position, pull up on the handle and
push the handle in until all 3 notches are inside the frame.
Note: The last notch on the handle does not latch on the
slot.
To release the drive wheels, pull up on the handle and pull it
out until the last notch engages in the slot. Then push the
handle down.
1. Handle in—normal operating position
2. All notches inside frame
3. Handle out—hydrostatic-drive release
4. Last notch engaged in slot
Specifications
Note: Specifications and design are subject to change
without notice.
Width
Length (operating)
Length (with handle stored)
Figure 7
(Figure
8) releases the
Figure 8
76 cm (30 inches)
137 cm (54 inches)
95.25 cm (37.5 inches)
Height (operating)
Height (with handle stored)
Weight
Torque Requirements
Bolt Location
Engine mounting bolts
Clutch mounting bolts
Slicer shaft nut
Attachments/Accessories
Approved attachments and accessories are available for use
with the machine to enhance and expand the capabilities
of the machine. Contact an Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
11
113 cm (44.5 inches)
73.5 cm (29 inches)
120.2 kg (265 lb)
Torque
37 to 45 N-m (27 to 33 ft-lb)
66 to 83 N-m (49 to 61 ft-lb)
88 to 115 N-m (65 to 85 ft-lb)