Storage; Removing The Machine From Storage - Toro 23510 Operator's Manual

Storage

1. Raise the cutting blades, stop the machine, stop the
engine, and disconnect the spark-plug wire.
2. Remove dirt and grime from the entire machine.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the engine.
3. Service the air cleaner; refer to
Cleaner (page 20).
4. Change the engine oil; refer to
Oil (page 20).
5. Grease the slicer-shaft bearings; refer to
the Slicer-shaft Bearings (page
6. For storage over 30 days, prepare the machine as
follows:
A. Add a petroleum-based stabilizer/conditioner
to fuel in the tank. Follow mixing instructions
from stabilizer manufacturer. Do not use
an alcohol-based stabilizer (ethanol or
methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline and used
at all times.
B. Run the engine until it stops from running out
of fuel.
C. Choke the engine.
D. Start and run the engine until it will not start again.
E. Dispose of fuel properly. Recycle the fuel
according to local codes.
Important: Do not store stabilizer/conditioned
gasoline over 90 days.
7. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
8. Paint all scratched or bare metal surfaces with paint
from an Authorized Service Dealer.
9. Store the machine in a clean, dry garage or storage area.
10. Cover the machine to protect it and keep it clean.
Removing the Machine from
Storage
1. Check and tighten all fasteners.
2. Inspect the spark plug and replace it if it is dirty, worn,
or cracked; refer to the engine Operator's Manual.
3. Install the spark plug until it is hand-tight, then an
additional 1/2 turn if it is new; otherwise, tighten it an
additional 1/8 to 1/4 turn.
Servicing the Air
Servicing the Engine
Lubricating
19).
29
4. Perform any needed maintenance procedures; refer to
Maintenance (page 18).
5. Check the engine oil level; refer to
Oil Level (page 12).
6. Fill the fuel tank with fresh gasoline; refer to
7. Connect the wire to the spark plug.
Checking the Engine
(page ).