Storage; Storage Safety; Storing The Machine - Toro 23512 Operator's Manual

Note:
If necessary, use 2 people to tilt the
machine rearward.
5. Clean the debris between the frame and the
seed gate.
6. Lubricate the sliding surface between the frame
and seed gate with a dry lubricant.
7. Return the machine to the upright position.
8. Fill the fuel tank.
9. Connect the wire to the spark plug.

Storage

Storage Safety

•
Park the machine on a level surface, shut off the
engine, wait for all moving parts to stop, engage
the parking brake, and allow the machine to cool
before storing it.
•
Do not store the machine or fuel near flames or
drain the fuel indoors.

Storing the Machine

1. Raise the cutting blades, stop the machine, shut
off the engine, and disconnect the spark-plug
wire.
2. Remove dirt and grime from the entire machine.
Important:
with mild detergent and water. Do not
pressure-wash the machine. Avoid
excessive use of water, especially near the
engine.
3. Service the air cleaner; refer to
Cleaner (page
4. Change the engine oil; refer to
Engine Oil (page
5. Grease the slicer-shaft bearings; refer to
Lubricating the Slicer-Shaft Bearings (page
6. For storage over 30 days, prepare the machine
as follows:
A. Add a petroleum-based
stabilizer/conditioner to fuel in the
tank. Follow mixing instructions from
stabilizer manufacturer. Do not use an
alcohol-based stabilizer (ethanol or
methanol).
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and
used at all times.
B. Run the engine until it stops from running
out of fuel.
C. Choke the engine.
D. Start and run the engine until it will not start
again.
E. Dispose of fuel properly. Recycle the fuel
according to local codes.
Important:
Do not store fuel containing
stabilizer/conditioner longer than the
duration recommended by the fuel stabilizer
manufacturer.
7. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
30
You can wash the machine
Servicing the Air
20).
Changing the
21).
19).