Storage; Removing The Machine From Storage - Toro 23511 Operator's Manual

Storage

1. Raise the cutting blades, stop the machine, stop the
engine, and disconnect the spark plug wire.
2. Remove dirt and grime from the entire machine.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the engine.
3. Service the air cleaner; refer to Servicing the Air
Cleaner (page 17).
4. Change the engine oil; refer to Changing the Engine
Oil (page 17).
5. For storage over 30 days, prepare the traction unit as
follows:
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
stabilizer manufacturer (1 oz. per gallon). Do
not use an alcohol based stabilizer (ethanol
or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline and used
at all times.
B. Run the engine until it stops from running out
of fuel.
C. Choke the engine.
D. Start and run the engine until it will not start again.
E. Dispose of fuel properly. Recycle the fuel
according to local codes.
Important: Do not store stabilizer/conditioned
gasoline over 90 days.
6. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
7. Paint all scratched or bare metal surfaces with paint
from an Authorized Service Dealer.
8. Store the machine in a clean, dry garage or storage area.
9. Cover the machine to protect it and keep it clean.
Removing the Machine from
Storage
1. Check and tighten all fasteners.
2. Inspect the spark plug and replace it if it is dirty, worn,
or cracked; refer to the engine Operator's Manual.
3. Install the spark plug until it is hand-tight, then an
additional 1/2 turn if it is new, otherwise, tighten it an
additional 1/8 to 1/4 turn.
4. Perform any needed maintenance procedures; refer to
Maintenance (page 16).
5. Check the engine oil level; refer to Checking the Engine
Oil Level (page 13).
6. Fill the fuel tank with fresh gasoline; refer to Adding
Fuel (page 13).
7. Connect the wire to the spark plug.
22