1. Operator presence bail
•
To stop the cutting blades, release the operator presence
bail.
Figure 8
Depth Control Lever
The depth control lever allows you to set the depth of the
cutting blades in 10 cutting positions along with one position
for transportation. To adjust the depth, remove the hairpin
cotter, pull the locking pin out, and move the lever forward or
rearward to the desired depth setting (Figure 9).
Important: Do not pull the lever side to side as this
will bend it.
3
1. Depth control lever
2. Transport position hole
Seeding Rate Gauge
Use the seed rate gauge to set the seed flow rate. It is
calibrated with the machine speed to give you an even seeding
rate at any speed. To change the seeding rate, loosen the
knob on the gauge and move the gauge pointer to the desired
position, then tighten the knob to hold it in place.
11
1
Figure 9
3. Hairpin cotter
4. Locking pin
2
4
g019441