Table of Contents
Advertisement
8.
Paint all scratched or bare metal surfaces with
paint from an Authorized Service Dealer.
9.
Store the machine on a level surface in a clean,
dry garage or storage area.
10.
Cover the machine to protect it and keep it clean.
Removing the Machine
from Storage
1.
Check and tighten all fasteners.
2.
Inspect the spark plug and replace it if it is dirty,
worn, or cracked; refer to the engine owner's
manual.
3.
Install the spark plug until it is hand-tight, then
an additional 1/2 turn if it is new; otherwise,
tighten it an additional 1/8 to 1/4 turn.
4.
Perform any needed maintenance procedures;
refer to
Maintenance (page
5.
Check the engine-oil level; refer to
Engine-Oil Level (page
6.
Fill the fuel tank with fresh fuel; refer to
Fuel (page
12).
7.
Connect the wire to the spark plug.
18).
Checking the
21).
Adding
31
Advertisement
Table of Contents
