Seasonal Storage; Preparing The Water System; Preparing The Engine; Preparing The Traction Unit - Toro 09802 HydroJect 3010 Operator's Manual

Seasonal Storage

Preparing the Water System

Important
It is very important that the water system be
drained to avoid freezing and damaging the components.
Drain system as follows:
1. Stop the engine, remove the key from the ignition
switch, and remove the wires from the spark plugs.
2. Remove the 2 screws securing the drive shield to the
frame and remove the shield.
3. With the engine "OFF" and the key removed from
ignition, rotate the drive coupling by hand until
resistance is felt. Continue to rotate the coupling about
1/4 revolution, opening the cycling valve.
4. Using the appropriate reducers (National Pipe thread),
connect a source of compressed air (maximum pressure
150 psi; minimum pressure 90 psi) to the water inlets on
either side of the machine.
Danger
Compressed air can penetrate the skin and cause
physical harm.
• Use extreme caution and wear protective goggles
and gloves when working with high pressure air.
• Get prompt medical attention if an injury
occurs.
5. Let compressed air flow through the machine for 3
minutes. While compressed air is flowing, temporarily
open the spray wash and high pressure drain valve,
purging water from the spray wash and high pressure
system.
6. Disconnect compressed air and reducers. Install the
drive shield previously removed and tighten the relief
valve tube.
7. Remove and drain the water filter container. Install a
new filter and replace the filter container.

Preparing the Engine

1. Drain the engine oil from the crankcase.
2. Remove and discard the oil filter. Install a new filter.
3. Refill the engine with 2 qts. of recommended motor oil.
4. Start the engine and run it at idle speed for two minutes.
Do not run it for longer than two minutes.
5. Stop the engine; remove the spark plugs.
6. Pour one ounce of clean engine oil into the spark plug
holes.
7. With the spark plugs removed, crank the engine with
the starter for a least 12 revolutions to distribute oil in
the cylinders.
8. Install the spark plugs.
9. Drain the gasoline from the fuel tank and fuel lines.
Reinstall all lines and secure all connections.
10. Thoroughly clean and service the air cleaner.
11. Check the oil filler cap and fuel tank cap to ensure that
they are securely in place.

Preparing the Traction Unit

1. Thoroughly clean the machine.
2. Grease or oil all fittings and pivot points.
3. Check to make sure that all tires are over-inflated to
20–30 p.s.i.
4. Lightly sand and use touch up paint on all areas that are
scratched, chipped, or rusted.
5. Drain and replace the hydraulic oil and filter on the cam
gear case.
6. Drain and replace the oil in the water pump case.
7. Clean the battery, terminals, and posts with a wire brush
and baking soda solution. Coat the cable terminals and
battery posts with skin over grease or petroleum jelly.
Recharge the battery.
34