Check Rear Axle (Model 30242 Only); Check Bidirectional Clutch Lubricant (Model 30242 Only) - Toro 30241 Operator's Manual

Check Rear Axle
(Model 30242 only)
The rear axle has three separate reservoirs which use SAE
80W-90 wt. gear lube. Although the axle is shipped with
lubricant from the factory, check the level before operating
the machine.
1. Position the machine on a level surface.
2. Remove check plugs from axle and make sure lubricant
is up to bottom of each hole. If level is low, remove fill
plugs and add enough lubricant to bring the level up to
the bottom of the check plug holes (Fig. 21 & 22).
Figure 21
1. Check plug
Figure 22
1. Fill/check plug
(one on each end of axle)
2. Fill plug
23
Check Bidirectional Clutch
Lubricant
(Model 30242 only)
1. Position the machine on a level surface.
2. Rotate clutch (Fig. 23) so check plug (shown in 12
O'clock position) is positioned at 4 O'clock.
Figure 23
1. Bidirectional clutch
3. Remove check plug. Fluid level should be up to hole in
clutch. If fluid level is low, add Mobil Fluid 424. Clutch
should be approximately 1/3 full.
4. Install check plug.
Note: Do not use engine oil (i.e. 10W30) in bidirectional
clutch. Anti–wear and extreme pressure additives will
cause undesirable clutch performance.
2. Check plug