Table of Contents
Advertisement
Maintenance
Engine Oil
Change oil:
After the first 8 operating hours.
After every 100 operating hours.
Note:
Change oil more frequently when
operating conditions are extremely
dusty or sandy.
Oil Type: Detergent oil (API service SG or SH)
Crankcase Capacity: w/filter, 2.1 qt. (2 l)
Viscosity: See table below
USE THESE SAE VISCOSITY OILS
10W–30, 10W–40
5W–20, 5W–30
–20
0
20
40
32
F
–30
–20
–10
0
C
22
60
80
100
10
20
30
40
Changing/Draining Oil
1.
Start the engine and let it run five minutes. This
warms the oil so it drains better.
2.
Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil
drains completely. Then lower the loader arms,
chock the wheels and turn the ignition key to
"OFF" to stop the engine. Remove the key.
3.
Place a pan below the oil drain. Remove the oil
drain cap (Fig. 10).
4.
When oil has drained completely, install the
drain cap.
Note:
Dispose of the used oil at a certified
recycling center.
1
Figure 10
1. Oil drain cap
5.
Slowly pour approximately 80% of the specified
amount of oil specified, page 22, into the filler
tube. Now check the oil level; refer to Checking
Oil Level, page 10. Slowly add additional oil to
bring to "FULL" mark on dipstick.
m–3216
Advertisement
Table of Contents
