Servicing The Engine Oil - Toro 22327 Operator's Manual

Compact tool carrier
Hide thumbs Also See for 22327:
Table of Contents

Advertisement

Important:
Do not press on the soft inside
area of the filter.
4.
Install the air-cleaner cover with the dust cap
oriented downward and secure the latches
(Figure
41).
5.
Close the hood.

Servicing the Engine Oil

Service Interval: Before each use or daily—Check
the engine-oil level.
After the first 50 hours—Change the engine oil
and filter.
Every 100 hours—Change the engine oil.
(Service more frequently if conditions are
extremely dusty or sandy.)
Every 200 hours—Change the oil filter. (Service
more frequently if conditions are extremely
dusty or sandy.)
Engine-Oil Specifications
Oil Type: Detergent diesel engine oil (API service
CH-4 or higher)
Crankcase Capacity: with filter 5.7 L (1.5 US gallons)
Viscosity: See the table below.
Figure 42
Checking the Engine-Oil Level
1.
Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2.
Shut off the engine, remove the key, and allow
the engine to cool.
3.
Open the hood and secure the prop rod.
4.
Clean the area around the oil dipstick and oil-fill
cap
(Figure
43).
1. Oil-fill cap
5.
Check the oil and add additional oil as needed
(Figure
44).
Important:
with oil; if the oil in the crankcase is too high
and you run the engine, you may damage the
engine.
g238048
Changing the Engine Oil
1.
Start the engine and let it run for 5 minutes.
Note:
This warms the oil so that it drains better.
2.
Park the machine on a level surface.
3.
Raise the loader arms and secure with the
cylinder locks; refer to
(page
26).
31
Figure 43
2. Oil dipstick
Do not overfill the crankcase
Figure 44
Using the Cylinder Locks
g029940
g029301

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tx 100022327g22327hd2232822328hd

Table of Contents