Table of Contents
Advertisement
3.
Connect an end of the positive (+) jumper cable
to the jump post
(Figure
4.
Connect the other end of the positive (+) jumper
cable to the positive terminal of the battery in
the other machine.
5.
Connect an end of the negative (-) jumper cable
to the negative post of the battery in the other
machine.
6.
Connect the other end of the negative (-) jumper
cable to a ground point, such as an unpainted
bolt or chassis member.
7.
Start the engine in the other machine. Let it run
a few minutes, then start your engine.
8.
Remove the cables in the reverse order of
connection.
9.
Install the cover to the jump post.
52).
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or a short.
53
illustrates the fuse block and identifies the fuse
positions.
1. Fuse (10 A)
2. Fuse (15 A)
Note:
If the machine does not start, either the main
circuit or the control panel/relay fuse could be blown.
There is also a fuse (50 A) located on the right side
of the machine. Raise the loader arms, install the
cylinder lock, and remove the right access cover. The
fuse is located just inside the frame.
1. Bolt
2. Right access cover
39
Figure 53
3. Fuse (15 A)
4. Fuse (10 A)
Figure 54
3. Fuse location
Figure
g029409
g205353
Advertisement
Table of Contents
