Removing/Installing The Hood; Greasing The Traction Unit; Servicing The Air Cleaner - Toro Dingo 323 Operator's Manual

Removing/Installing the Hood

Removing the Hood
Before performing many maintenance procedures, you
will need to remove the hood.
1. Raise the loader arms and install the cylinder locks;
refer to Using the Cylinder Locks, page 17.
Note: In the case that you need to remove the hood
without raising the loader arms, be very careful not to
damage the hood or hydraulic hoses as you maneuver the
hood out from under the arms.
2. Stop the engine and remove the key.
3. Release the four locking tabs (Fig. 15).
Figure 15
1. Locking tabs
4. Pull the hood off of the traction unit.
Installing the Hood
1. Position the hood over the traction unit frame with the
posts on the hood fitting into the holes on the frame
(Fig. 15).
2. Secure the hood by pushing the locking tabs forward
and down (Fig. 15).

Greasing the Traction Unit

Grease all pivot joints every 8 operating hours and
immediately after every washing.
Grease Type: General-purpose grease.
1. Lower the loader arms and stop the engine. Remove
the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting (Fig. 16 and 17).
1
m–4395
4. Pump grease into the fittings until grease begins to
ooze out of the bearings (approximately 3 pumps).
5. Wipe up any excess grease.

Servicing the Air Cleaner

Replace the primary filter every 200 operating hours.
Replace the secondary filter yearly.
Note: Replace the filters more frequently if operating
conditions are extremely dusty or sandy.
Important
may damage them, allowing contaminants into the engine.
Removing the Filter
1. Lower the loader arms and stop the engine. Remove
the key.
2. Release the latches on the air cleaner and pull the air
cleaner cover off of the air cleaner body (Fig. 18).
3. Clean the inside of the air cleaner cover with
compressed air.
22
Figure 16
Figure 17
Do not clean the filters. Cleaning them
m–4396
m–4056