Operation; Installing And Removing The Attachment; 4-In-1 Operation And Control; Transport Position - Toro TX 1000 Operator's Manual

Operation

The 4-in-1 bucket can be used in 4 different operating
modes:
•
Bucket
•
Blade
•
Leveller
•
Grapple bucket
Installing and Removing
the Attachment
Refer to the Operator's Manual for the traction unit for
the installation and removal procedure.
Important:
Before installing the attachment,
position the machine on a level surface, ensure
that the mount plates are free of any dirt or debris,
and ensure that the pins rotate freely. If the pins
do not rotate freely, grease them.
Note:
Always use the traction unit to lift and move
the attachment.
WARNING
If you do not fully seat the quick-attach
pins through the attachment mount plate,
the attachment could fall off the machine,
crushing you or bystanders.
Ensure that the quick-attach pins are fully
seated in the attachment mount plate.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid injected
into the skin must be surgically removed
within a few hours by a doctor familiar with
this form of injury; otherwise, gangrene may
result.
• Ensure that all hydraulic-fluid hoses
and lines are in good condition and all
hydraulic connections and fittings are tight
before applying pressure to the hydraulic
system.
• Keep your body and hands away from
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks; never use your hands.
CAUTION
Hydraulic couplers, hydraulic lines/valves,
and hydraulic fluid may be hot. If you contact
hot components, you may be burned.
• Wear gloves when operating the hydraulic
couplers.
• Allow the machine to cool before touching
hydraulic components.
• Do not touch hydraulic fluid spills.
4-in-1 Operation and
Control
After you attach the 4-in-1 bucket to the mount plate
of the traction unit, ensure that the hydraulic couplers
are connected, and that the auxiliary hydraulics low
flow system is turned on. Start and run the machine at
full throttle.
When loading material, always have the bucket level
to the ground and move forward into the material to
be lifted. When the bucket is full, tilt it rearward to
decrease the lifting resistance when you lift the load.

Transport Position

When transporting a load, keep the attachment as
close to the ground as possible, no more than 6
inches above the lowest position. Tilt it rearward to
keep the load level.
1. No more than 6 inches
above the lowest position
20
Figure 31
2. Tilt the load rearward
g240205