Completing The Installation; Product Overview; Controls - Toro TX 1000 Operator's Manual

9

Completing the Installation

No Parts Required
Procedure
1. Tilt the 4-in-1 bucket back and lower the loader
arm.
2. Shut off the engine and remove the key.
3. Check all hydraulic connections for leaks and
correct as necessary.
4. Check the hydraulic fluid level and correct as
necessary; refer to your machine Operator's
Manual.
5. Install the heat shield as shown in
6. Close and secure the engine hood.
7. Install the valve manifold cover to the 4-in-1
bucket and secure it with the 4 bolts and
washers as shown in
Important:
The 4-in-1 bucket must not
be used without the valve manifold cover
installed. The warranty on the valve manifold
assembly will be voided if the cover is not
installed or installed incorrectly.
Figure 18.
Figure 24.

Product Overview

1. 4-in-1 bucket
2. Manifold cover

Controls

Become familiar with all the controls
Figure 30) before you start the engine and operate
the traction unit.
Auxiliary Hydraulics Low Flow
Switch
Press on the front of the auxiliary hydraulics low flow
switch to turn it on.
1. Low flow switch
17
Figure 28
3. Hydraulic and electrical
connections
4. Loader arm/attachment tilt
lever
(Figure 29
Figure 29
g242329
and
g239507