4.
Route the loader end branch into the rear of the
machine along the lower front end of the loader
arm valve assembly
the right hose access
Figure 11
1. Loader end branch
Figure 12
1. Right hose access
2. Loader end branch
(Figure
11) and out through
(Figure
12).
2. Right hose access
3. Outer protective sleeve
5.
Route the loader end branch up into the outer
protective sleeve, then route it along the bottom
of the inner hydraulic hose so that the wires
reach the 7-pin connector.
6.
Install the plug nut (large) and then the grommet
(small, narrow end facing the 7-pin connector)
over the wires.
g242387
1. Plug nut
7.
Remove the top half of the 7-pin connector and
install the 4 loader end wires into the correct
connector terminals inside as shown in
14.
g242409
1. Wire harness retainer
2. White - Terminal 6
3. Black - Terminal 5
10
Figure 13
2. Grommet
Figure 14
4. Yellow - Terminal 2
5. Black - Terminal 7
g242237
Figure
g242270