Removing/Installing The Hood; Greasing The Traction Unit - Toro 22305 Operator's Manual

Maintenance Service
Interval
200 hours
400 hours
Yearly/Storage
1
More often in dusty, dirty conditions.
2
Change oil after the first 50 operating hours.
3
Change the hydraulic filter and torque the lug nuts after the first 8-10 operating hours
4
For severe duty or rental applications, change every 100 operating hours.
5
For severe duty or rental applications, change every 200 operating hours.
6
For severe duty or rental applications, change every 400 operating hours.
Important
Refer to your engine operator's manual for additional maintenance procedures.
Note: After 50 hours and then every 100 hours thereafter (that is at 150, 250, 350, etc.) the screen displays CHG OIL to
remind you to change the oil. After every 100 hours, the screen displays SVC to remind you to perform the other
maintenance procedures based on a 100, 200, or 400 hour schedule. These reminders come on starting three hours prior to
the service interval time and flash at regular intervals for six hours.
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the wires from the spark plugs before you do
any maintenance. Set the wire aside so that it does not accidentally contact the spark plug.

Removing/Installing the Hood

Removing the Hood
Before performing many maintenance procedures, you
will need to remove the hood.
1. Raise the loader arms and install the cylinder locks;
refer to Using the Cylinder Locks, page 18.
Note: In the case that you need to remove the hood
without raising the loader arms, be very careful not to
damage the hood or hydraulic hoses as you maneuver the
hood out from under the arms.
2. Stop the engine and remove the key.
3. Release the four locking tabs (Fig. 17).
Maintenance Procedure
Change engine oil filter (every other oil change)
Check engine speed (1400 rpm idle and 3600 full throttle,
Check spark plugs
1, 3, 5
Change hydraulic filter
Inspect fuel lines for leaks
1, 6
Change hydraulic oil
Replace primary and secondary air filters
1
Replace the fuel filter
Touch up chipped paint
Caution
21
1, 4
1
Figure 17
1. Locking tabs
4. Pull the hood off of the traction unit.
Installing the Hood
1. Position the hood over the traction unit frame with the
posts on the hood fitting into the holes on the frame
(Fig. 17).
75)
1
m–4395