Setup; Loose Parts; Installing The Valve Lever; Charging The Battery - Toro Dingo 323 Operator's Manual

Setup

Note: Determine the left and right side of the machine from the normal operating position.

Loose Parts

Note: Use the chart below to verify that all parts have been shipped.
DESCRIPTION
Speed selector lever assembly
Key
Hydraulic oil filter
Drain hose

Installing the Valve Lever

1. Remove and discard the nut securing the bolt and
washer to the speed selector lever.
2. Secure the lever to the speed selector valve using the
bolt and washer as illustrated in Figure 2.
Figure 2
1. Speed selector lever
QTY.
1
2
m–8204
2. Speed selector valve
1 Install the speed selector lever
2 Start engine
1 Break-in oil change
1 Drain the engine oil

Charging the Battery

Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Warning
Battery terminals or metal tools could short
against metal components, causing sparks. Sparks
can cause the battery gasses to explode, resulting
in personal injury.
• When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the traction unit.
• Do not allow metal tools to short between the
battery terminals and metal parts of the
traction unit.
1. Park the traction unit on a level surface, raise the
loader arms, and install the cylinder locks; refer to
Using the Cylinder Locks, page 17.
2. Stop the engine and remove the key.
9
USE