Loading The Machine; Using The Z Stand - Toro 74919TE Operator's Manual

Loading the Machine

Use extreme caution when loading the machine onto a trailer
or a truck. One full-width ramp that is wide enough to extend
beyond the rear tires is recommended instead of individual
ramps for each side of the machine (Figure 39). The lower
rear section of the machine frame extends back between the
rear wheels and serves as a stop for tipping backward. Having
a full-width ramp provides a surface for the frame members
to contact if the machine starts to tip backward. If it is not
possible to use one full-width ramp, use enough individual
ramps to simulate a full-width continuous ramp.
The ramp should be long enough so that the angles do not
exceed 15 degrees (Figure 39). A steeper angle may cause
mower components to get caught as the unit moves from the
ramp to the trailer or truck. Steeper angles may also cause
the machine to tip backward. If loading on or near a slope,
position the trailer or truck so that it is on the down side
of the slope and the ramp extends up the slope. This will
minimize the ramp angle. The trailer or truck should be as
level as possible.
Important: Do not attempt to turn the machine while
on the ramp; you may lose control and drive off the side.
Avoid sudden acceleration when driving up a ramp and
sudden deceleration when backing down a ramp. Both
maneuvers can cause the machine to tip backward.
WARNING
Loading a machine onto a trailer or truck increases
the possibility of backward tip-over and could cause
serious injury or death.
• Use extreme caution when operating a machine
on a ramp.
• Ensure that the ROPS is in the up position while
using the seat belt when loading the machine.
Ensure that the ROPS will clear the top of an
enclosed trailer.
• Use only a single, full-width ramp; do not use
individual ramps for each side of the machine.
• If individual ramps must be used, use enough
ramps to create an unbroken ramp surface wider
than the machine.
• Do not exceed a 15-degree angle between the
ramp and the ground or between the ramp and
the trailer or truck.
• Avoid sudden acceleration while driving the
machine up a ramp, to avoid tipping backward.
• Avoid sudden deceleration while backing
the machine down a ramp, to avoid tipping
backward.
1. Trailer
2. Full-width ramp
Using the Z Stand®
The Z Stand® raises the front end of the machine to allow
you to clean the mower and remove the blades.
WARNING
The machine could fall onto someone and cause
serious injury or death.
• Use extreme caution when operating the
machine on the Z Stand®.
• Use only for cleaning the mower and removing
the blades.
• Do not keep the machine on the Z Stand for
extended periods of time.
• Always turn the engine off, set the parking
brake, and remove the key before performing
any maintenance to the mower.
Driving up onto the Z Stand
Important: Use the Z Stand on a level surface.
1. Raise the mower to the transport position.
2. Remove the bracket pin (Figure 40).
30
Figure 39
3. Not greater than
15 degrees
4. Full-width ramp—side
view