Belt Maintenance; Inspecting The Belts; Replacing The Mower Belt - Toro 74902TE Operator's Manual

With 48 turbo force side discharge mower
Hide thumbs Also See for 74902TE:
Table of Contents

Advertisement

Belt Maintenance

Inspecting the Belts

Service Interval: Every 50 hours
Check the belts for squealing when the belt is rotating, blades
slipping when cutting grass, frayed belt edges, burn marks and
cracks are signs of a worn mower belt. Replace the mower
belt if any of these conditions are evident.

Replacing the Mower Belt

Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks and cracks are
signs of a worn mower belt. Replace the mower belt if any of
these conditions are evident.
Important: The fasteners on the covers of this machine
are designed to remain on the cover after removal.
Loosen all of the fasteners on each cover a few turns so
that the cover is loose but still attached, then go back
and loosen them until the cover comes free. This will
prevent you from accidentally stripping the bolts free
of the retainers.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Lower the mower to the 76 mm (3 inch) height of cut.
4. Remove the belt covers and the bolts attached to them
(Figure 77).
1
Figure 77
1. Loosen the bolt
5. Use a ratchet in the square hole in the idler arm to
remove tension on the idler spring (Figure 78).
6. Remove the belt from the mower deck pulleys.
7. Remove the belt guide on the spring loaded idler arm
shown in Figure 78.
8. Remove the existing belt.
9. Install the new belt around the mower pulleys and the
clutch pulley under the engine (Figure 78).
2
2. Remove belt cover
1. Clutch pulley
2. Mower belt
3. Spring loaded idler pulley
4. Ratchet
10. Install the belt guide on the idler arm shown in Figure
78.
11. Using the ratchet in the square hole, install the idler
spring (Figure 78).
Make sure the spring ends are seated in the anchor
grooves.
12. Install the belt covers (Figure 79).
G012433
50
Figure 78
5. Square hole in the idler
arm for the ratchet
6. Idler grease zerk
7. Belt guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z master professional 6000 seriesZ master 74902te

Table of Contents