Specifications - Toro 74902TE Operator's Manual

Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage the electric
clutch and drive the mower blades. Pull the switch up to
engage the blades and release. To disengage the blades, push
the blade control switch (PTO) down or move a motion
control lever into the neutral lock position.
Ignition Switch
This switch is used to start the mower engine and has three
positions: Start, Run and Off.
Motion Control Levers
The motion control levers are used to drive the machine
forward, reverse, and turn either direction.
Neutral Lock Position
The neutral lock position is used with the safety interlock
system and to determine neutral position.
Fuel Shut-off Valve
Close the fuel shut-off valve (under the seat) when
transporting or storing the mower.
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.

Specifications

Note: Specifications and design are subject to change
without notice.
Width:
Without Deck
Deflector Up
Deflector Down
Length:
Roll Bar - Up
Roll Bar - Down
Height:
Roll Bar - Up
179.1 cm (70.5 inches)
Weight:
Model
74902TE
15
48 Deck
116.1 cm (45.7 inches)
137.2 cm (54.0 inches)
161.5 cm (63.6 inches)
48 Deck
201.2 cm (79.2 inches)
205.5 cm (80.9 inches)
Roll Bar - Down
118.9 cm (46.8 inches)
Weight
556 kg (1226 lb)