Table of Contents
Advertisement
The hours are displayed when the key is off or when
the machine is running.
Note:
If the ignition key is turned to the ON position
for a few seconds before cranking the engine, the
battery voltage will display in the area where the hours
are normally displayed.
Note:
The LCD indicators appear when each of the
control meets the "safe to start" mode.
Fuel Shut-Off Valve
Located on the left side of the machine, towards the
rear of the engine.
The fuel shut-off valve is used to shut off the fuel when
the machine will not be used for a few days, during
transport to and from the jobsite, and when parked
inside a building.
Align valve handle with the fuel line to open. Rotate
90° to close.
Drive-Wheel Release Valves
Located on the right rear corner of the hydrostatic
pumps.
The drive-wheel release valves are used to release
the hydrostatic drive system to allow the machine to
be moved by hand without the engine running.
With a wrench (5/8 inch), turn both of the valves one
turn counterclockwise to release the drive system.
Turn clockwise to reset the drive system. Torque to
12 to 15 N∙m (110 to 130 in-lb). Do not overtighten.
Do not tow the machine.
PTO Switch
Located in the center of the console control below the
hour meter
(Figure
6).
The switch must be pulled out (up) to engage the
blades. Switch is pushed in to disengage the blades.
The LCD indicator will disappear when the PTO switch
is engaged
(Figure
8).
Deck Lift Handle
Located on the right side of the front control panel.
Pull the handle rearward to raise the cutting deck.
Allow the handle to move forward to lower the cutting
deck to the cut height that has been set.
Pull the handle all the way rearward to latch the
cutting deck into the raised transport position. Pull
rearward and push the button down, on the top of the
lever, to unlatch from transport.
Specifications
Note:
Specifications and design are subject to
change without notice.
Cutting width
Width with
deflector down
Width with
deflector raised
Length
Height
Weight (weight
will vary slightly
depending on the
deck size)
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to
www.Toro.com
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
12
32in Mower Deck
36in Mower Deck
81.3 cm
(32 inches)
114 cm
(44.9 inches)
85.6 cm
(33.7 inches)
(36.6 inches)
(58.6 inches)
334 to 354 kg
(737 to 781 lb)
for a list of all
91.4 cm
(36 inches)
121.9 cm
(48 inches)
93.0 cm
148.8 cm
(75 inches)
120.1 cm
Advertisement
Table of Contents
