Maintaining The Chassis; Checking For Loose Hardware; Cleaning; Cleaning And Storing Safety - Toro Grandstand HDM 74532 Operator's Manual

Maintaining the Chassis

Checking for Loose
Hardware
Service Interval: Before each use or daily
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Visually inspect the machine for any loose
hardware or any other possible problem. Tighten
the hardware or correct the problem before
operating.

Cleaning

Cleaning and Storing Safety

•
Park machine on level ground, disengage drives,
set parking brake, stop engine, remove key, and
disconnect spark plug wire. Wait for all moving
parts to stop before leaving the operator's position.
Allow the machine to cool before servicing,
adjusting, fueling, cleaning, or storing.
•
Clean grass and debris from the cutting unit,
muffler, drives, grass catcher, and engine
compartment to prevent fires.
•
Allow the machine to cool before storing the
machine in any enclosure. Do not store the
machine or fuel container, or refuel, where there
is an open flame, spark, or pilot light such as on a
water heater or other appliance.

Clean Debris From Machine

Service Interval: Before each use or daily
1. Stop engine, wait for all moving parts to stop,
and remove key. Engage parking brake.
2. Clean off any oil, debris, or grass build-up on
the machine and cutting deck, especially under
deck belt shields, around the fuel tank, around
engine and exhaust area.
Important:
You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use
of water, especially near the control panel,
around the engine, hydraulic pumps, and
motors.
Clean Engine and Exhaust
System Area
Service Interval: Before each use or daily (May be
required more often in dry or dirty
conditions.)
CAUTION
Excessive debris around engine cooling air
intake and exhaust system area can cause
engine, exhaust area, and hydraulic system to
overheat which can create a fire hazard.
Clean all debris from engine and exhaust
system area.
1. Stop engine, wait for all moving parts to stop,
and remove key. Engage parking brake.
41