Product Overview; Controls - Toro Grandstand HDM 74532 Operator's Manual

Product Overview

1. Parking-brake lever
2. Height of cut
3. Deck lift
Figure 4

4. Controls

5. Motion controls
Controls
Become familiar with all the controls before you start
the engine and operate the machine.
Motion Control Levers
The motion control levers, located on each side of the
top console, control the forward and reverse motion
of the machine.
Moving the levers forward or backward turns the wheel
on the same side forward or reverse respectively. The
wheel speed is proportional to the amount the lever
is moved.
Moving the levers outward, from the center position
into the notch, locks them in the neutral position.
g463501
1. Neutral lock position
(handles out)
2. Neutral operate position
(handles in)
3. Front of machine
4. Reverse
Note:
When the levers are out in the neutral position,
the neutral LCD indicator will appear, but the Operator
Presence will not.
Note:
When either lever is moved inward from
the neutral position, the neutral LCD indicator will
disappear and the Operator Presence indicator will
appear.
Choke Control
Located on the left side of the control console
6).
The choke is used to aid in starting a cold engine.
Moving the choke lever forward will put the choke
in the ON position and moving the choke lever to
the rear, to the detent, will put the choke in the OFF
10
Figure 5
5. Rear reference bar
6. Front reference/speed
control bar
7. Forward
8. Adjustment hole
g224633
(Figure