Table of Contents
Advertisement
Loading the Machine
WARNING
Loading a machine on a trailer or truck
increases the possibility of backward tip-over.
Backward tip-over could cause serious injury
or death.
• Use extreme caution when operating a
machine on a ramp.
• Use only a single, full width ramp; Do not
use individual ramps for each side of the
machine.
• If individual ramps must be used, use
enough ramps to create an unbroken ramp
surface wider than the machine.
• Avoid sudden acceleration while driving
machine up a ramp to avoid tipping
backward.
• Avoid sudden deceleration while backing
machine down a ramp to avoid tipping
backward.
Use extreme caution when loading machines
on trailers or trucks. One full width ramp that is
wide enough to extend beyond the rear tires is
recommended instead of individual ramps for each
side of the machine. A full width ramp provides a
surface to walk on behind the machine. If it is not
possible to use one full width ramp, use enough
individual ramps to simulate a full width continuous
ramp.
A steep ramp angle may cause components to get
caught as the machine moves from ramp to trailer or
truck. Steeper angles may also cause the machine to
tip backward. If loading on or near a slope, position
the trailer or truck so it is on the down side of the
slope and the ramps extends up the slope. This will
minimize the ramp angle. The trailer or truck should
be as level as possible.
Important:
Do not attempt to turn the machine
while on the ramp, you may lose control and drive
off the side.
Avoid sudden acceleration when driving up a ramp
and sudden deceleration when backing down a
ramp. Both maneuvers can cause the machine to tip
backward.
23
Advertisement
Table of Contents
