Table of Contents
Advertisement
inflation pressure for tires is 90 kPa (13 psi).
Adjust if necessary.
4.
Pull the deck lift handle all the way rearward to
latch the cutting deck into the raised transport
position.
5.
Insert the height adjustment pin into the 7.6 cm
(3 inches) cutting height location.
6.
Release the transport lock and allow the deck to
lower to the cutting height.
7.
Raise the discharge deflector.
8.
Carefully rotate the blades front to rear. Measure
from the level surface to the front tip of the
center blade. The measurement should read
7.6 cm (3 inches).
Note:
In most conditions, the back tips on the
side blades should be adjusted 3.2 to 6.4 mm
(1/8 to 1/4 inch) higher than the front.
Figure 31
1. 7.9 to 8.3 cm (3-1/8 to
3-1/4 inches)
2. Back blade tip
3. Front blade tip
9.
Raise the deck to transport position.
10.
Slowly loosen the adjusting screw on the lift
assist spring until the screw can be removed
(Figure
32). Save the screw for reinstallation.
g014790
4. 7.6 cm (3 inches)
5. Level surface
1. Adjusting screw
2. Bracket
11.
Set the height of the cut lever to the 7.6 cm (3
inches) position. Place a 6.7 cm (2-5/8 inches)
tall block under the front deck skirt and a 7.0 to
7.3 cm (2-3/4 to 2-7/8 inches) block under the
rear skirt.
12.
Loosen the hardware at the bottom of all four
lift chains so the deck is sitting securely on
the blocks
(Figure
removed from the lift chains and retighten the
hardware.
39
Figure 32
3. Gap
33). Make sure the slack is
g313830
Advertisement
Table of Contents
