Check The Spark Arrester (If Equipped) - Toro 74902TE Operator's Manual

Installing the Spark Plug
Tighten the spark plug(s) to 22 N-m (16 ft.-lb).
Figure 59
Install the hydraulic unit shroud (Figure 56).
Check the Spark Arrester (if
equipped)
Service Interval: Every 50 hours
WARNING
Hot exhaust system components may ignite
gasoline vapors even after the engine is stopped.
Hot particles exhausted during engine operation
may ignite flammable materials. Fire may result in
personal injury or property damage.
Do not refuel or run engine unless spark arrester
is installed.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Wait for muffler to cool.
3. If any breaks in the screen or welds are observed,
replace the arrester.
4. If plugging of the screen is observed, remove the
arrester and shake loose particles out of the arrester
and clean screen with a wire brush (soak in solvent if
necessary). Install arrester on exhaust outlet.
41