Adjusting The Traction Control Neutral Position; Adjusting The Tracking Of The Traction Control, Full Forward Position - Toro 22321 Operator's Manual

1. Traction control
5. Adjust the traction control so that it rests flush
against the reference bar when it is pulled straight
back (Figure 50 and Figure 51).
6. Tighten the flange nut and bolt in the traction
control stem.
Adjusting the Traction Control
Neutral Position
If the traction unit creeps forward or backward when
the traction control is in neutral and the unit is warm,
immediately complete the following procedure:
1. Lift/support the traction unit so that both tracks are
off of the ground.
2. Open the rear access cover.
3. Loosen the jam nuts on the traction rods, under the
control panel (Figure 52).
Figure 50
2. Stem , bolt and nut
Figure 51
1. Traction rod
4. Start the traction unit and set the throttle to about
1/3 open position.
When the traction unit is running, you could be
caught and injured in moving parts or burned
on hot surfaces.
Stay away from pinch points, moving parts,
and hot surfaces when adjusting the running
traction unit.
5. If the left track moves, lengthen or shorten the right
traction rod until the track stops moving.
6. If the right track moves, lengthen or shorten the left
traction rod until the track stops moving.
7. Tighten the jam nuts.
8. Close the rear access cover.
9. Stop the engine and lower the traction unit to the
ground.
10. Drive the traction unit in full reverse, checking to
see if the unit tracks straight. If it does not, note
the direction the traction unit veers. Repeat the
adjustment previously described so that it tracks
straight in reverse.
Adjusting the Tracking of the
Traction Control, Full Forward
Position
If the traction unit does not drive straight when you hold
the traction control against the reference bar, complete
the following procedure:
37
Figure 52
2. Jam nut