Table of Contents
Advertisement
Figure 11
1. Height-of-cut lever
2. Clevis pin
5. Lower the height-of-cut lever onto the clevis pin.
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the PTO and move the control levers to the
neutral locked position and apply the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. After adjusting the height-of-cut, remove the nut and
washer while holding the stud with a wrench (Fig. 12).
Note: Do not remove the wheel nut and washer (Fig. 12).
1
2
3
m-3654
3. Hairpin cotter
17
4
3
2
m–4167
Figure 12
1. Gage wheel
2. Stud
3. Washer
4. Select a hole so that the gage wheel is positioned to the
nearest corresponding height-of-cut desired (Fig. 12).
5. Install the stud nut and washer (Fig. 12).
6. Repeat the adjustment on the other gage wheels.
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are
most comfortable.
1. Raise the seat and loosen the adjustment knobs
(Fig. 13).
2. Move the seat to the desired position and tighten the
knobs.
1
Figure 13
1. Adjustment knobs
1
5
4. Nut
5. Wheel nut and washer.
Do not remove.
m–5163
Advertisement
Table of Contents
