Pushing The Machine By Hand - Toro 74702 Operator's Manual

Adjusting the Motion Control
Levers
The motion control levers can be adjusted higher or lower
for maximum operator comfort.
1. Remove the 2 screws and curved washers holding the
control lever to the control arm shaft (Fig. 14).
2. Move the control lever to the next set of holes. Secure
the lever with the 2 screws and curved washers. The
cupped side of the washer should be toward the control
arm shaft (Fig. 14).
3. Repeat the adjustment on the other control lever.
1
2
3
Figure 14
1. Control lever
2. Screw
4
m–5215
3. Curved washer
4. Control arm shaft
18

Pushing the Machine by Hand

Important
Always push the machine by hand. Never
tow the machine because damage may occur.
To Push the Machine
1. Disengage the PTO and move the control levers to the
neutral locked position and apply the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Pull the two bypass levers up and push them until the
washer on the rod passes through the slot. Push the
levers down to lock them in place (Fig. 15).
4. Disengage the parking brake to push the machine.
2
Figure 15
1. Position for pushing the
machine
To Operate the Machine
Pull each bypass lever up and pull them completely out.
Push the levers down (Fig. 15).
Note: The machine will not drive unless the bypass levers
are pulled out.
1
m–5139
2. Position for operating the
machine