Adjusting The Motion-Control Levers; Pushing The Machine By Hand - Toro 74760 Operator's Manual

Adjusting the
Motion-Control Levers
Adjusting the Height
The motion-control levers can be adjusted higher or
lower for maximum operator comfort
Figure 22
Adjusting the Tilt
The motion-control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever
to the control arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever fore or aft
bolts to secure the control in the new position.
3. Repeat the adjustment for the opposite control
lever.
Pushing the Machine by
Hand
Important:
Always push the machine by hand.
Never tow the machine because damage may
occur.
This machine has an electric brake mechanism and to
push the machine the ignition key needs to be in the
R position. The battery needs to be charged and
UN
functioning for the electric brake to be disengage.
Pushing the Machine
1. Park the machine on a level surface and
disengage the blade-control switch.
2. Move the motion-control levers outward to
the P position, stop the engine, and wait
ARK
(Figure 22).
g027252
(Figure 22). Tighten both
for all moving parts to stop before leaving the
operating position.
3. Locate the bypass levers on the frame on both
sides of the engine.
4. Move the bypass levers forward through the key
hole and down to lock them in place as shown in
Figure 23 . Ensure this is done for each lever.
5. Move the motion-control levers inward to the
N position and turn the ignition key to the
EUTRAL
R position. Do not start the machine.
UN
The machine is now able to be pushed by hand.
1. Bypass lever location
2. Lever position for
operating the machine
6. When finished, ensure the key has been
returned to the S
the battery charge.
If the machine fails to move the electric brake may
still be engaged. If necessary the electric brake can
be released manually. Refer to
Brake (page 41).
Operating the Machine
Move the bypass levers rearward through the key hole
and down to lock them in place as shown in
Ensure this is done for each lever.
25
Figure 23
3. Lever position for pushing
the machine
position to avoid draining
TOP
Releasing the Electric
Figure
g017303
23.