Removing The Mower - Toro 74760 Operator's Manual

1. Adjusting rod
2. Adjusting block
7. To raise the front of the mower, tighten the
adjustment nut. To lower the front of the mower,
loosen the adjustment nut.
8. After adjustment, check the front-to-rear slope
again. Continue adjusting the nut until the front
blade tip is 1/16-5/16 inch (1.6-7.9 mm) lower
than the rear blade tip
9. When the front-to-rear blade slope is correct
check the side-to-side level of the mower again;
refer to Leveling from Side-to-Side (page

Removing the Mower

1. Park the machine on a level surface and
disengage the blade-control switch.
2. Move the motion-control levers outward to the
P position, stop the engine, remove the
ARK
key, and wait for all moving parts to stop before
leaving the operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Remove the hairpin cotter from the front support
rod and remove the rod from the deck bracket
(Figure 57). Carefully lower the front of the
mower deck to the ground.
Figure 56
3. Lock nut
(Figure 47).
g014634
1. Front support rod
2. Locking nut
5. Lift the mower deck and hanger brackets clear
of the rear lift rod and lower the mower carefully
to the ground
44).
1. Mower deck
2. Hanger bracket
6. Slide the mower deck rearward to remove the
mower belt from the engine pulley.
7. Slide the mower deck out from underneath the
machine.
Note:
46
Figure 57
3. Deck bracket
(Figure 58).
Figure 58
3. Rear lift rod
Retain all parts for future installation.
g014635
g005077